|
CAP1000 OP |
|
| 10-Oct-96 | Install machine + checkout + maintenance |
| 16-Oct-96 | Replaced main bushing, Y axis coupling, WC and cylinder, and prog move pads |
| 26-Nov-96 | Y axis Encoder problems - replaced cable |
| 12-Dec-96 | Fuse blowing on ServoControlBoard - found broken Motor wire |
| 18-Jul-97 | Annual maintenance - replace all 3 cond. Wires |
| 16-Oct-97 | Adjust air flow valve for shot pins - replace lower left shot pin sensor |
| 20-Feb-98 | Control corrupt - reload machine parameters |
| 10-Jun-98 | Replaced lower turret bearings |
| 30-Jul-98 | Annual maintenance - Repaired anvil locking bolt - Added shim between anvil and frame - Replaced Station 19 & 20 die holder |
| 07-Aug-98 | Adjusted momentary near switch |
| 10-Aug-98 | Adjusted clutch dump sensor gap |
| 03-Dec-98 | Repair upper shot pin assembly |
| 01-Jan-99 | Repaired X motor cable - tightened brake key clamp |
| 05-Jan-99 | Replaced control batteries |
| 30-Jun-99 | Replaced clutch valve |
| 28-Sep-99 | Anvil bolts broken - replaced and added shim to anvil |
| 08-Dec-99 | Cure turret problems - anvil & drive |
| 12-Jan-00 | Replace lower rt shot pin cylinder |
| 04-Feb-00 | Replace upper shot pin out sensor |
| 23-Mar-00 | Changed turret bearings and adjust turret height |
| 21-Jun-00 | Turret location problems, cleaned brake pads and adjusted momentary near |
| 17-Jul-00 | Annual maintenance |
| 15-Feb-01 | Repair shot pin problems. Shim upper shot pin housing |
| 11-Jun-01 | Reset punch timing tapes, adjust air pressure and parameters |
| 25-Jun-01 | Fuse blown at 24V PS |
| 03-Jul-01 | Foot pedal causing 24V fuse blow |
| 02-Aug-01 | Preventive maintenance |
| 02-Aug-01 | Install new drive shaft |
| 10-Jul-02 | Requires Brake valve |